#Scp toolkit slow how to#
#Scp toolkit slow drivers#

Close any running DS4Windows instances and extract the new version to where you have DS4Windows.exe, overwriting any files when prompted.

If you already have DS4Windows setup, it should be working fine when tested with XInputTest.

Download the latest version of ryochan DS4Windows fork from their GitHub releases page here.

#Scp toolkit slow drivers#

For DS3 controllers, please note that you must plug them in via USB AT LEAST ONCE (meaning that they show up in ScpMonitor/PadTest as connected via USB) so that the calibration data can be downloaded, otherwise gyroscope measurements WILL BE WRONGĭS4Windows (supports DS4 controllers ONLY, but uses the normal USB drivers and the Windows Bluetooth stack).The controllers should sync up and XInputTest should show the same results as last time.Finally, restart the 'SCP DSx Service' the same way you stopped it, just click Start in the right-click dropdown menu instead of Stop in services.msc.If you've used Windows Explorer's zip functionality to extract the files, you will have to go to their new location, right click the dll files you've just overwritten, go to Properties, and click the Unblock button, then OK.Then extract the patch archive you downloaded to whereever you installed ScpToolkit to (usually the ScpToolkit folder in your Program Files directory), overwriting any files when prompted.To overwrite the files, you will have to close any running ScpServer windows (check the tray too) and stop the 'SCP DSx Service' (accessible by running services.msc from the Windows Run prompt).If that's all good, then download the version of my ScpToolkit patch that matches your ScpToolkit version from my fork's releases page here.After it's setup and detecting your controllers (can verify by running ScpMonitor), test them out with XInputTest.Run the installer and driver installer as you would usually (going through the steps of the driver installer, and following it's instructions).Download the latest version of ScpToolkit (1.7 at the top of the page) from the official releases page here.

Please follow one of the following guides (depending on your preferred software and controller type): ScpToolkit (supports DS3 and DS4 controllers, but requires that you dedicate a Bluetooth dongle to it) This page will explain the various software you can setup to feed motion data to cemuhook

#Scp toolkit slow how to#

UDP Pad motion data provider setup How to setup your input software to provide motion sensor data